



RUST AWAY Non Acidic Rust, Iron, Metal, Bore and Fertiliser Remover
Product details
- Non Acidic, Non Etching Cleaner
- Perfect for Acid Sensitive Surfaces
- Helps Remove Rust, Iron, Bore and Metal Oxide Stains
Couldn't load pickup availability
Pickup available at KURNELL
Usually ready in 24 hoursProfessional Grade · Sealers Plus (an Aqua-Seal brand)
Fast dispatch from Kurnell, NSW
Not sure? Call +61 2 9521-4000
Prefer to buy in store? Find a stockist

RUST AWAY – Non Acidic Rust, Iron, Metal, Bore and Fertiliser Remover
Full description
About RUST AWAY
Rust Away is a pH neutral, non-acidic rust, iron, bore and metal oxide cleaner and remover for a wide range of surfaces.
Technical Bulletin (PDF) ›Description
Rust Away is a Professional Grade, pH Neutral, Non Acidic, Rust, Iron, Bore and Metal Oxide Cleaner and Remover. Also helps remove stains from rust water, iron fertilisers, metal marks, metal shavings and metal scrapes from metal furniture etc. Fast acting, non-etch formula. Safe for acid sensitive surfaces. For indoor, outdoor, domestic and commercial areas.
Works on & where to use
Works on: porcelain, ceramic, encaustic and tessellated tiles, terrazzo, bricks, pavers, concrete, mosaics, terracotta, saltillo, quarry tiles, engineered stone, and all natural stone e.g. basalt, bluestone, granite, marble, limestone, quartz, sandstone, slate, travertine etc. Ideal for acid sensitive surfaces.
Test first: always test first in an inconspicuous area to determine ease of application, dwell time, colour stability and desired results. The end user must determine suitability for their use.
What you need
- Mask, protective gloves, eye, skin and foot protection and a watch for timing
- Plastic bucket plus clean sponge, roller or mop to apply the product
- Hose or separate bucket and mop plus plenty of clean water for rinsing
- Scrub'N'Clean Kit, white nylon pads or scrub brush
- Tip: for large areas, use a wet vac to help remove Rust Away from the surface before rinsing with clean water
How to use
Ready to use formula. Do not dilute.
- Sweep, vacuum, or wipe surface
- Pour or spray Rust Away directly onto stain
- Allow to dwell for 5-10 minutes depending on the severity or type of problem. Do not allow to dwell longer than 10 minutes. Note: stain will immediately start to turn purple
- Do not allow product to dry on the surface - add more Rust Away as needed to keep it wet and active
- After dwell time, scrub with a white pad or scrub brush
- Remove dirty solution with paper towels or absorbent cloths
- Rinse thoroughly with clean water
- Repeat the process as necessary
Important notes: long dwell times might cause slight dullness or colour discolouration on some sensitive surfaces - always do a test area first.
Limitations
- Will not be effective if the stains or marks are not iron based or if covered by a sealer or a coating. Remove sealer or coating with Strip-It then use Rust Away
- If the stain or mark is not metal based, refer to the website for the appropriate stain removal or problem solving product
Coverage
Approximately 5-10 m² per litre. Coverage will vary depending on porosity of surface, time the solution is left to dwell on the surface, and the type and severity of the problem.
Precautions & safety directions
- Read entire label, SDS and technical bulletin before using
- Wear appropriate gloves, skin and eye protection
- Do not breathe in fumes or vapours - wear an appropriate mask. Use in a well ventilated area
- Do not eat, drink or smoke when using this product
- Use when surface temperature is between 4°C and 28°C
- Do not allow contact with non recommended surfaces
- Do not mix with other chemicals
- WASH UNDERSIDE OF SHOES BEFORE STEPPING ONTO OTHER AREAS.
Handling, storage, clean up & first aid
Handling & storage: close container tightly after each use and keep upright. Store locked up in original container in a well ventilated cool area and protect from sunlight. Keep or store away from combustible materials. Shelf life is approx 3 years in an unopened container, less after opening. Storage beyond that time does not mean the product is not usable - do a test area first.
Clean up: do not re-use container. Rinse and discard in rubbish. Wash tools, gloves and shoes with water before they dry.
First aid: immediately contact the Poisons Centre (Australia Ph: 131-126, NZ Ph: 0800 764-766) or a doctor. Ingestion: rinse mouth, do not induce vomiting. Eyes: rinse cautiously with water for several minutes, remove contact lenses if present and easy to do, continue rinsing. Clothes: remove contaminated clothing and wash before use. Skin & hair: wash with plenty of soap and water. Inhalation: remove victim to fresh air and keep at rest in a comfortable position for breathing. General: if any irritation persists or feeling unwell, get medical advice.
How to use, product details and information
What to use on
Surfaces
Tap a surface to see every product for it. Always test in an inconspicuous area first. Not sure? Use the Product Selector below.
How much do I need?
WATCH: HOW TO USE
Remove rust from stone, concrete, pavers & tiles
Non-acidic rust remover
Questions about a product or your project? Our team is here Monday to Friday.
-
Call us
-
Email us
-
Shipping
See our shipping policy for delivery times and costs.
-
Product Selector
Answer 3 quick questions on our Product Selector.
